vedi se così va meglio...
PS: uso abitualmente manuali in inglese perché sono più precisi e completi.

Ho supposto la tua sia un MY 2000, in ogni caso non cambia nulla.

Saluti

Document ID# 624597
2000 Chevrolet Corvette


--------------------------------------------------------------------------------

Evaporator Drain Hose Replacement
Removal Procedure



Immagine:

11,68KB


Caution: Before servicing any electrical component, the ignition key must be in the OFF or LOCK position and all electrical loads must be OFF, unless instructed otherwise in these procedures. If a tool or equipment could easily come in contact with a live exposed electrical terminal, also disconnect the negative battery cable. Failure to follow these precautions may cause personal injury and/or damage to the vehicle or its components.

Disconnect the negative battery cable.
Remove the battery. Refer to Battery Replacement in Engine Electrical.
Remove the battery heat shield. Refer to Battery Heat Shield Replacement in Body Front End.
Remove the evaporator and HVAC module drain tube from the HVAC module.
Installation Procedure



Immagine:

12,23KB


Install the evaporator and HVAC module drain tube to the module; orientate the drain tube to contact the dash panel as shown (1).
Check to be sure that the drain tube is fully seated to the HVAC module.
Install the battery heat shield. Refer to Battery Heat Shield Replacement in Body Front End.
Install the battery. Refer to Battery Replacement in Engine Electrical.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

Connect the negative battery cable.

Tighten
Tighten the negative battery cable bolt to 15 N·m (11 lb ft).


--------------------------------------------------------------------------------
Document ID# 624597
2000 Chevrolet Corvette